1994 Jeep Wrangler Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 1994 Jeep Wrangler
Verified by mechanics, reported by drivers like you
Ask a mechanic in our community
Never overpay. Check prices with our estimator
1994 Jeep Wrangler ProblemsThrottle Position Sensor May Fail
The throttle position sensor (TPS) may fail causing intermittent drivability problems like hard starting, stalling, and/or hesitation when accelerating. A failed TPS will require replacement, proper diagnoses should always be performed before replacing any parts.
Leaks at the front and/or rear differential pinion seal and from the transfer case are common. Leakage from the transfer case normally occurs at the case-mating surfaces and require removal of the transfer case to reseal.
Loose or worn suspension and steering components can cause a wobble or shaking in the steering wheel. It may happen at a certain speed and subside as the vehicle accelerates through the range. Tire balance can contribute to this as well.
1994 Jeep Wrangler QuestionsWhen turning key to start position it blows ecu/fuel fuel any ideas? (2 answers)
I sent my ecu out to get checked. The guy told me the capacitors where bad and he fixed it and sent it back. I put it in and it did the same exact thing. The vehicle was running fine then just shut off. It cranks strong but blows fuse everytime
My 1994 Jeep Wrangler 4 cyl std hasn't been going over 50 mph. So the highway is a nightmare need help fixing the problem. I'm going like 50 mph on the 5th gear which is the last gear on the highway and the engine sounds like its revving asking for the for the next gear but there isn'...
I have juice from the battery, all wires are connected, the starter has been tested and works. I have not checked ignition switch but it would be the last resort. I have tested power at the terminals on the solenoid and have juice there as well. Is there a way to test the "starter" f...