2010 Jeep Grand Cherokee Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2010 Jeep Grand Cherokee
- how do I change filter and transmission fluid on jeep 2010 grand cherokee
- replaced coolant thermostat, put in coolant, what would make it run hot?
- My check 4 wd drive system comes on and off along with abs warning lights.
- what is a faint click in the tranny at 2nd gear shift?
- what is click noise after tranny chng to 2nd gear only after car turned,off never again during stop &go driving
2010 Jeep Grand Cherokee Problems
Temperature blend and recirculation doors commonly fail, which can cause the AC modes not to change or the temperature to be different on the left and right sides. If replacing blend air doors, a recirculation door, a door link, or a sub-assembly housing, new heating, ventilation and AC (HVAC) sub-assemblies are available that improve reliability.
Due to warped front brake rotors or variations in the thickness of the rotors, brake pulsations may develop. The best method to reduce pulsations is to use an "On the Car" brake lathe (as long as the rotors are suitable for turning). "On the Car" equipment can correct variations (or "runout") in the rotor surfaces because it also corrects variations in other components (e.g. the hub).
If the transmission delays initial gear engagement after being parked overnight or longer, it may be due to a suspect transmission cooler return filter. If the transmission was recently serviced and the part number for the cooler return filter contains an "AB" suffix at the end, a new filter should be installed.
2010 Jeep Grand Cherokee Questions
for the timing belt
2010 Jeep Grand Cherokee Recalls
The 4-wheel drive transfer case can direct engine power to the rear wheels only, all four wheels, or in its neutral position, non at all. These vehicles are being recalled because the transfer case can shift into its neutral position without warning. If this were to occur, engine power would not reach any of the drive wheels and the vehicle could not move under its own power. Dealers will reprogram the final drive controller which governs the transfer case to correct this concern.
Chrysler is recalling 2010 Chrysler 300, Dodge Challenger, Charger, Jeep Commander, Grand Cherokee, and Dodge Ram vehicles due to a problem with the wireless ignition node (Win) module, which can exhibit a binding condition of the solenoid latch. It's possible that the key can be removed from the ignition switch prior to placing the shifter in "Park," which can cause unintended vehicle movement. Dealers will inspect and replace the Win module free of charge.
Chrysler is recalling 2010 Jeep Commander and Grand Cherokee vehicles because the rear track bar may have been manufactured improperly. This can cause reduced vehicle stability, which can increase the risk of a crash. Dealers will inspect the rear track bar bushing retaining hoop and replace the rear track bar, if necessary.