2007 Jeep Grand Cherokee Repair and Maintenance

A guide to problems, costs, maintenance and repair for your 2007 Jeep Grand Cherokee

Repair Estimates
Caret_down

Never overpay. Check prices with our estimator

2007 Jeep Grand Cherokee
$
323
to $
574
2007 Jeep Grand Cherokee
$
305
to $
629
2007 Jeep Grand Cherokee
$
89
to $
617
2007 Jeep Grand Cherokee
$
152
to $
462
2007 Jeep Grand Cherokee
$
596
to $
739

2007 Jeep Grand Cherokee Problems

Engine Will not Start Due to Wireless Control Module Fault

A no crank or no start condition may develop due to electronic lockup of the wireless control module (WCM), also referred to as the Sentry Key Remote Entry Module (SKREEM). When this module fails the remote keyless entry system will also not operate. The WCM is commonly replaced to correct this concern.

Check Engine Light due to cylinder #3 misfire

A Check Engine Light may illuminate indicating a "Cylinder #3 Misfire." This normally occurs in hot weather after the vehicle has been driven, parked for ten to twenty minutes, and then restarted. Heat from the exhaust vaporizes fuel inside the #3 fuel injector and causes the misfire. Installing an insulator sleeve normally lowers the temperature enough so the fuel will not vaporize.

Check Engine Light Due to Failed Thermostat

The thermostat may fail to close completely, causing the Check Engine Light to illuminate. This problem will prevent the engine from reaching normal operating temperature; a new thermostat should be installed.

See More Problems (17)

2007 Jeep Grand Cherokee Questions

Won't start? Makes click noise and the truck will not start up. (2 answers)

I recently bought 2007 Jeep.The previous owner was involved in an accident and didn't want to spend money for the repair.So we bought it assume that it was only body repair it needed.We replaced bumper,radiator,headlights and front cradle. Had it test drive for about a week or so and then it...

This is a Hemi. I have a code P2181 and vehicle sounds like engine is revving very high, but tachometer remains steady (1 answer)

Changed my rear brakes, installed new rotors and pads. Passenger side works fine. On the drivers side the outside pad is only making contact on the top half of the rotor. Can't get the pad to make full contact to the rotor. Inside pad works fine. (1 answer)

Cleaned & lubricated the bushings, replaced the anti-rattle clips on the caliper.

See More Questions (38)

2007 Jeep Grand Cherokee Recalls

The Engine May Turn Off Unexpectedly

While operating the vehicle the driver may hit the ignition key with their knee, accidentally moving the key out of the run position. If this were to occur the engine would turn off, affecting various safety systems and increasing the risk of a crash and/or personal injury. As of this writing, the remedy for this recall is still under development.

The Transfer Case may Shift into Neutral Unexpectedly

The 4-wheel drive transfer case can direct engine power to the rear wheels only, all four wheels, or in its neutral position, non at all. These vehicles are being recalled because the transfer case can shift into its neutral position without warning. If this were to occur, engine power would not reach any of the drive wheels and the vehicle could not move under its own power. Dealers will reprogram the final drive controller which governs the transfer case to correct this concern.

See More Recalls (2)

2007 Jeep Grand Cherokee Reviews

I have been having a problem with my 2007 Jeep Grand Cherokee since I bought the car new, the problem is when I am at a stop and begin to accelerate a hesitation occurs like the car is not getting gas and my dash lights all light up, the problem was intermittent when I bought the car and now it is happening every other day. If I pull over and shut the car off and re-start it runs O.K. but it ke...
my only complaint is the gas mileage at 14.5 city/highway combined is horrible by any std.

See More Reviews (2)