A popping or groan type noise may occur when opening or closing one or more of the vehicle doors. This may be caused bu insufficient lube on the lower hinge roller axle. Applying a small amount of grease between the roller pin and the inside surface should correct this concern. Our technicians tell us if the grease is not applied in the correct location, the noise will remain.
Resources for the Repair and Maintenance of your 2009 Jeep Commander
2009 Jeep Commander
2009 Jeep Commander Problems
The hard drive for the MYGIG radio may become corrupt. Symptoms would include: The radio does not go past the "Navigation is being activated" screen, music on the hard drive cannot be accessed, capacity of the hard drive shows 0. If all three of these symptoms are present the MYGIG radio software will require updating.
The fuel tank may become hard to fill and/or the fuel fill nozzle may shut off repeatedly while fueling. Our technicians tell us that various items including the fuel tank, vapor recirculation tube, fuel fill tube, or EVAP system canister control valve may be at fault. Proper diagnoses will be required to determine the exact cause of this concern.
On Vehicles with a 4.7L or 5.7L V8 engine, the Check Engine Light may illuminate with code P2181 for a cooling system performance fault. Or technicians tell us that updated software for the powertrain control module (PCM) is available to correct this concern.
Vehicles with manual temperature control may develop a condition where warm air is coming from the instrument panel outlets when cold has been selected. Our technicians tell us a revised air distribution housing is available to correct this concern.
2009 Jeep Commander Recalls (Recent)
RepairPal Expert Overview:
The 4-wheel drive transfer case can direct engine power to the rear wheels only, all four wheels, or in its neutral position, non at all. These vehicles are being recalled because the transfer case can shift into its neutral position without warning. If this were to occur, engine power would not reach any of the drive wheels and the vehicle could not move under its own power. Dealers will reprogram the final drive controller which governs the transfer case to correct this concern.
RepairPal Expert Overview:
Wiring may be reversed on the steering column control module driver's air bag connector and cause the driver air bag not to deploy. If the driver's air bag does not inflate when needed, the risk of injuries to the driver is increased. Dealers will inspect the driver's air bag squib wires and replace the steering column control module. The recall began in May, 2009. The recall number is J13.
2009 Jeep Commander Questions and Answers
I'm driving a rental on 2009 jeep commander, how do I turn on 4wd?
I have a 2009 jeep commander. Last week my engine light went on and I took it into the shop and they told me mp problem was code P013C. After I left the engine light went out. I thought everything ...