2006 Infiniti G35 Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2006 Infiniti G35
2006 Infiniti G35 Problems
The crankshaft angle sensor or the camshaft position sensor can fail and cause loss of engine power, an engine that cuts out, and other drivability problems. This will cause the Check Engine Light to illuminate. Certain models have been involved in a recall to replace the camshaft and crankshaft sensors. For more information on this recall, please click here»
2006 Infiniti G35 Questions
My car will not going over 4000rpms neither in tiptronic mode nor will it accelerate over 2nd gear. The acceleration is also really slow.
I'm familiar with the famous G35 defective compression rod bushing issue and had the bushing replaced (4 times and counting on same side) but the knocking/clunking noise continued to occur over bumps, gravel, compacted snow, etc. At the mechanics advice, the sway bar links, strut mount and up...
it needs 'cam sensors' Was this caused by the timing belts?
2006 Infiniti G35 Recalls
The wiring connecting the belt tension sensor and the occupant detection sensor control unit under the passenger front seat can move, causing wear and oxidization of the wire connector terminals. These terminal issues can result in interruption of the electrical signal. In the event of a crash, the passenger airbag may not deploy, increasing the risk of injury. Dealers will perform the necessary repairs to correct this issue. This recall is expected to begin on July 12, 2010.
Certain vehicles may contain headlights that do not meet Federal Motor Vehicle Safety Standards. Specifically # 108 "Lamps, reflective devices, and associated equipment. This may increase the risk of accidents both during the day and at night. Dealer will replace headlight assemblies. The Infiniti recall # is N/A - Service bulletin # is 06V394000
2006 Infiniti G35 Reviews
I've had this car for about 4 months now and love it. I do wish the trunk opening and trunk were as large as my Camry.