2000 Honda Civic Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2000 Honda Civic
Verified by mechanics, reported by drivers like you
Ask a mechanic in our community
Never overpay. Check prices with our estimator
Our experts translate recalls into plain English
2000 Honda Civic ProblemsHood Release Cable May Break at Handle
On some models the hood release cable breaks at the hood release handle.
Damaged engine mounts can lead to vibration and roughness felt in the steering wheel. A rattle in the dash and engine area may also be heard. Replacement of damaged mounts will commonly correct these issues.
Impact damage to the front of the vehicle can cause the primary oxygen sensor to blow fuse 15 and cause the Check Engine light (MIL) to come on. In most cases the primary oxygen sensor needs replacing and a new fuse installed to repair the issue.
2000 Honda Civic QuestionsRadio is reading code error. What can I do? (1 answer)
It was after the battery was replaced. It was working fine before that
The copper fitting came with my new compressor clutch and dryer I do not know where this part goes can you please help me out
I did a head swap and it ran after, but now it won't start. Replaced distributor, main relay, did timing, and replaced the crank sensor. Any idea what could've caused this? By the way I also have good ground connections from motor to body. I even tried holding the spark plug wire to the n...
2000 Honda Civic RecallsHonda Recalls Certain 1998-2007 Civic CNG Vehicles to Add Insulation for the CNG Tank
Honda recalled certain compressed natural gas (CNG) Civic vehicles to add insulation to the rear seat back. In the event of an interior fire, the CNG tank could become compromised due to uneven heating, preventing the pressure relief safety device from functioning as designed. If the tank heats and does not vent the contents, the tank could rupture and explode. Dealers will install the insulation to help protect the tank from uneven heating.
The electrical contacts in the ignition switch may be worn. This may cause the engine to stall while driving, increasing the risk of a crash. Dealers will replace the ignition switch to correct this concern. This recall is expected to begin by June 14, 2002.
Honda is recalling certain sedan and coupe models for failing to comply with federal safety standards on seat belt assemblies. Certain rear seat belt buckles were improperly manufactured, which may cause the seat belts to be difficult to unfasten after a crash. Dealers will inspect and replace the seat belt assemblies free of charge.