2003 GMC Yukon Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2003 GMC Yukon
- whats making engine shuting down wile driving fule shuting down at diferent leve
- Yukon won't go into 4wd. Display says Service 4wd. Is there a way to engage it
- my yukon turns over trys to start but will not stay running
- The front vents are not allowing air. The other settings blow air.
- try starting and nothing just a lot of dinging from the car
2003 GMC Yukon Problems
The power door lock actuators may become slow to operate or stop working completely and require replacement.
2003 GMC Yukon Questions
but wile crank back when fule is added what is making this happen and what do I need to do to fix it
2003 GMC Yukon Recalls
The second row center seat belt routing may make it difficult to position correctly on smaller passengers. If the seat belt rides up to fit around the abdomen, the risk of internal injury is increased in a crash. Dealers will cut the guide loop, remove a portion of the loop, and the remaining sides should be folded over and secured with a retainer. The recall began July 21, 2005. The GM recall number is 05037.
The hydro-boost housing relief valve bore may be out of specification. The seal may fracture as a result, which may reduce braking assist and slightly increase the steering effort while braking. Under certain conditions, more braking effort will be required to stop the vehicle. Dealers will replace the hydro-boost relief valve. The recall began June 18, 2004. The GM recall number is 04004.
The courtesy lamps on affected running boards may overheat when exposed to moisture and road salt. Overheating may cause the lamps and boards to melt or start a fire. Dealers will replace the wiring harness for these running boards.
2003 GMC Yukon Reviews
2003 Yukon SLT. About 3 months ago my "low coolant warning" signal came on. So I took the truck in, they topped it over and said to just monitor it till I brang the truck back in a few weeks to do my routine oil change. A month later, sensor went off again. So I took it in to do a pressure test. They said the test came back okay, but that most of the liquid in my reservoir was water. So I had t...