The power door lock actuators may become slow to operate or stop working completely and require replacement.
Resources for the Repair and Maintenance of your 1994 GMC Yukon
1994 GMC Yukon
1994 GMC Yukon Problems
The anti-lock brake system (ABS) front wheel speed sensors are prone to failure. When a sensor fails, the ABS warning light may illuminate and/or the ABS system may activate erratically.
The inside and outside door handles are prone to breaking.
The fuel pump may fail causing the engine to stall and not restart. Our technicians recommend replacing the fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.
A coolant leak may develop from the water pump. This can result in an engine overheating condition. A leaking water pump will require replacement.
1994 GMC Yukon Recalls (Recent)
Summary: ON CERTAIN MINIVANS, PICKUP TRUCKS, AND SPORT UTILITY VEHICLES WITH CERTAIN MODEL-ENGINE COMBINATIONS, THE WINDSHIELD WIPER MOTOR MAY FAIL DUE TO CRACKED SOLDER JOINTS ON THE CONTROLLER CIRCUIT BOARD. THE WINDSHIELD WIPERS COULD WORK INTERMITTENTLY OR NOT AT ALL.Learn more »
Summary: VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS AND SPORT UTILITY VEHICLES, 2 AND 4-WHEEL DRIVE. SOLDER JOINTS NEAR THE WIRING HARNESS CONNECTOR CAN CRACK CAUSING THE WINDSHIELD WIPERS TO WORK INTERMITTENTLY.Learn more »
Summary: VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS, VANS AND MOTORHOMES EQUIPPED WITH ELECTRONICALLY FUEL INJECTED 6.5L DIESEL ENGINE. THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH FEDERAL REGULATION PART 573. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. THE CAMPAIGN WILL IMPROVE THE OVERALL DRIVEABILITY OF THESE VEHICLES.Learn more »
1994 GMC Yukon Questions and Answers
Torque specs. for link to sway bar??
no brake lights, what do you take off to check brake light bulbs
Only a very small amount of fuel comes out of the line when I turn the ignition. I can hear the pump, so I guess
it is not the pump relay.
Could the pump be bad if I can hear it? (only stays ...
Backup lights not working. Auto trans. Replaced bulbs, checked fuse ..suspect the backup switch Where is it located?