2012 GMC Yukon XL 2500 Repair and Maintenance Costs
A guide to repairs, service, and maintenance costs for your 2012 GMC Yukon XL 2500
Never overpay. Check prices with our estimator
2012 GMC Yukon XL 2500 ProblemsReduced Power and Check Engine Light
The 2008-2014 GMC Yukon XL 2500 uses a throttle position sensor (TPS) which commonly fails and causes:
- Check engine light illumination
- Reduced Power message
- OBD trouble code P2135
This issue is related to the throttle position sensor, and can be caused by faulty wiring to the TPS, bad connection at the TPS, or a failed TPS.
To correct this issue, the wiring harness, connector, and throttle position sensor must be inspected, tested, and/or replaced. The most common cause is a faulty TPS.
2012 GMC Yukon XL 2500 RecallsIgnition Switch
The ignition switch actuator can bind causing the ignition switch to stick in the "start" position. If this were to occur the actuator can unexpectedly release, cause the ignition switch to snap back into the "Accessory" position. This would cause the engine to turn off with an associated loss of brake and steering power assist. If these conditions were to lead to a crash the airbags may not deploy as expected. Dealers will inspect and replace the ignition lock housing as necessary to correct this concern.
The steering gear pitman shaft may not have been adequately hardened and could break. If this occurs, a loss of steering ability will result, increasing the risk of a crash. Dealers will inspect the steering gear and replace the steering gear pitman shaft if necessary to correct this concern. The General Motors recall number is 12005.