X

2007 GMC Sierra 2500 HD Repair and Maintenance

A guide to problems, costs, maintenance and repair for your 2007 GMC Sierra 2500 HD

2007 GMC Sierra 2500 HD Problems

One or more heater & AC (HVAC) temperature and/or air delivery mode door actuator may fail, resulting in improper temperature or air delivery. If this occurs, fault code(s) should be stored in the HVAC control module which should assist in diagnoses.

The daytime running lights are prone to burning out. Our technicians tell us that the light sockets may show signs of heat damage but usually are OK. Always be sure to use the correct replacement bulb for the best life expectancy. The new bulb recommendation for 2001-2003 models is #4114K (trade number).

Units with 4 wheel disk brakes may develop at situation where the park brake does not hold as it should. Our technicians tell us this can be caused by worn park brake shoes located inside the drum section of the rear brake disks. The worn shoes should be replaced and properly adjusted to correct this issue.

See More Problems 11

2007 GMC Sierra 2500 HD Questions

Really hard to steer in 4wd. Would rather drive it in 2wd and take my chances then fight 4wd. Then have to drive it about a mile for it to disengage. Then you can hear it disengage with a thump.

does this procedure also require removal of the timing cover

Where can I find an actual GM service manual? I found one online about 6 months ago but I cannot find one now at all. I have a 2007 Sierra 2500HD Classic with the 8.1L. Haynes or Chilton do not make one that covers my model.

See More Questions 10

2007 GMC Sierra 2500 HD Recalls

The heated washer module under the hood could overheat due to excessive current draw. Under certain conditions, this could result in an under hood fire. This previous recall attempt in 2008 to repair this concern did not have the expected success. Dealers will now permanently disable and remove the heated washer module to correct this concern. This recall is expected to begin on June 20, 2010.

The wiring to the washer system heater may overheat due to a failure in the heater module. This could cause other electrical features to malfunction, smoke to develop, and an electrical fire could result. Dealers will install a wire harness with an inline fuse to protect the washer heater module. This recall is expected to begin on September 12, 2008. The General Motors recall number is 08048.

See More Recalls 2