2006 GMC Canyon Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2006 GMC Canyon
Verified by mechanics, reported by drivers like you
Ask a mechanic in our community
Never overpay. Check prices with our estimator
2006 GMC Canyon ProblemsAC Blower Inop Due to Failed Resistor
The HVAC blower motor may stop working at one or more speeds due to a faulty blower motor resistor block. Our technicians recommend to confirm the resistor is at fault by first checking the operation of the switch.
The fuel level sensor in the fuel tank may fail causing erratic fuel gauge operation. Our technicians tell us that on high mileage vehicles you may wish to replace the complete fuel pump module assembly if this condition occurs.
2006 GMC Canyon QuestionsTheres an motor oil leak that caused the entire engine to drain (1 answer)
While I was driving on the freeway, the engine started to smoke. I pulled to the nearest gas station and the engine wasn't overheated (I checked and it was half way) the oil spit out to the side of the right tire and towards the underneath of the truck. Even got on the tail gate and inside th...
Ok so here recently I've had numerous problems with my '06 GMC Canyon Z71 (non-4x4) it all started with the right outer tie rod becoming loose. I replaced the tie rod but now it feels as if none of the axles are attached to the truck... for example I can be going straight and it feels as ...
truck is cranking almost sounds like it is not getting any fuel.
2006 GMC Canyon RecallsGM Recalls 2004–2011 Vehicles Due to Inaccessible Top Tether Anchor for Child Safety Seat
General Motors is recalling certain 2004–2011 Chevrolet Colorado, GMC Canyon, and Isuzu regular and extended cab models without a rear seat and equipped with a 60/40 front bench split seat for failing to comply with federal safety standards on child restraint anchorage systems. The top tether anchor for the front center seat is not accessible and the manual provides no instruction on its use. In order to correct the problem, dealers will cut a hole in the back panel trim cover to allow access to the top tether anchor and will provide supplemental instructions on the use of the top tether.
General Motors is recalling various 2004–2009 models in twelve Southern and Southwestern states, Puerto Rico, and the U.S. Virgin Islands due to contamination in the brake lamp switch, which may cause the brake lamps to fail or stay on continuously. This could lead to a crash since other drivers may not be aware of the operator's intentions. Dealers will inspect and replace the necessary components free of charge. For more information, call Chevrolet at 1-800-630-2438, GMC at 1-866-996-9463, or Isuzu at 1-800-255-6727.
The brake lights may fail to illuminate, or illuminate at all times. In this condition, the cruise control will not function. If towing a trailer connected to the brake lamp wiring, the trailer lights will also be affected. A following driver may not know when the brakes are applied, increasing the risk of a rear-end crash. Dealers will replace the brake lamp switch assembly. The recall began December 5, 2006. The GM recall number is 06030.