If the engine runs rough, stalls, hesitates on acceleration, is hard to start, or has generally poor performance, this can be caused by a cracked or broken air inlet tube. Loose clamps on the air tube can also cause this these problems. Tightening the air inlet tube, or replacing if broken, should correct the problem.
Resources for the Repair and Maintenance of your 1991 Ford Probe
1991 Ford Probe
1991 Ford Probe Problems
The thermostat may allow the engine to run too cool, which will cause it to run rough at idle. Replacing the thermostat should fix this concern if the engine is running too cool.
1991 Ford Probe Recalls (Recent)
Summary: BRACKETS MOUNTING AUTOMATIC SHOULDER BELT RETRACTOR ASSEMBLY MAY HAVE AN UNDERSTRENGTH SPOT WELD.Learn more »
Summary: NOTE: DRIVER'S SIDE (LEFT) PASSIVE SEAT BELT ASSEMBLY. THE RAIL OF THE AUTOMATIC SHOULDER BELT CAN WEAR SUFFICIENTLY SUCH THAT THE CABLE WHICH RETRACTS THE BUCKLE ASSEMBLY WILL BECOME JAMMED IN THE RAIL RENDERING THE SHOULDER BELT INOPERATIVE.Learn more »
Summary: NOTE: PASSENGER SIDE (RIGHT) SEAT BELT ASSEMBLY. THE RAIL OF THE AUTOMATIC SHOULDER BELT CAN WEAR SUFFICIENTLY SUCH THAT THE CABLE WHICH RETRACTS THE BUCKLE ASSEMBLY WILL BECOME JAMMED IN THE RAIL RENDERING THE SHOULDER BELT INOPERATIVE.Learn more »
1991 Ford Probe Questions and Answers
After making hard turns it dosen't repond to the excelerater. I want to use the car for SOLO compititions and I can't get it to accelerate out of the corners
Hi, 1991 ford probe here i need some help with. car turns over but wont start, new fuel pump,new relay,and inertia switch seems fine.pump works when jumped.found a couple blown fuses under dash -re...
how do I fix a climate control system when the heater is not heating at all, and the fan control switch only works on the highest setting (setting 4), the compressor only comes on when the fan swit...
All of the lights except for the head lights stoppped working and cant find a reason why?
my brothers car stalled and would not start, I found when I pulled the distributor cap off it was not turning so I pulled the timing belt cover off and found the pulley bolt broken. I found this af...