2000 Ford Focus Repair and Maintenance Costs
A guide to repairs, service, and maintenance costs for your 2000 Ford Focus
Never overpay. Check prices with our estimator
Ask a mechanic in our community
Our experts translate recalls into plain English
2000 Ford Focus ProblemsWarped Front Brake Rotors Can Cause Steering Wheel Shimmy
In areas of high corrosion rear wheel bearings tend to fail. Ford agreed to replace these failed bearings at no cost. This program was to expire on December 31, 2002. Our technicians tell us it is unlikely Ford will replace any more of these failed bearings free of charge.
2000 Ford Focus QuestionsMy back wheels are slanted in and when i go over bumps the back of the car moves (1 answer)
When i go over bumps the back of the car moves side ways
I just did a timing belt change, changed timing belt pulleys, the waterpump, added a cold air intake, autolite xp iridium plugs, motorcraft oil change with motorcraft filter cleaned the MAF using CRC maf cleaner, clean plug wire boots, freshly sealed the valve cover, flushed and cleaned the coo...
2000 Ford Focus RecallsFord Recalls 2000-2005 Focus Vehicles Due to Rear Door Latch Issues
Ford has recalled certain 2000-2005 Focus vehicles in states that use road salt because corrosion may build up at the pawl pivot area of the rear door latch. This may prevent the door from latching properly. If this occurs, an occupant could fall out of the vehicle. Dealers will install a lower rocker seal to the door to prevent corrosive material from entering and will evaluate the rear door latches, which will either be lubricated or replaced.
Ford has recalled certain 2000-2001 Focus vehicles because the filter in the fuel delivery module may be contaminated. This may cause reduced fuel pressure, which can lead to hesitation, loss of power, and surging. Dealers will replace the fuel delivery module.
Ford has recalled certain 2000-2001 Focus vehicles because the battery cable insulation may become damaged. This may cause the Check Engine Light to illuminate and the vehicle may fail to start. Dealers will secure the battery cables as necessary and verify proper routing. If insulation damage is present, the cable will be replaced.