2007 Ford E-250 Repair and Maintenance

A guide to problems, costs, maintenance and repair for your 2007 Ford E-250

No_car_image
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
Get a Repair Estimate For Your 2007 Ford E-250
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more

2007 Ford E-250 Problems

Rough Running Engine and Possible Check Engine Light

The Check Engine Light may illuminate, the engine may run rough and have misfires on acceleration. Commonly the ignition coils and/or the ignition coil boots are the cause of this problem. The rubber boot that insulates the coil to the spark plug can dry and crack allowing arcing. Inspect the coils and boots, and replace them as needed. Our technicians also recommend replacing the coil boots any time the spark plugs are replaced.

Loud Popping Noise and Misfire Experienced

The spark plugs may become dislodged from the cylinder heads. A loud popping noise can be heard and a subsequent misfire experienced. The threads on the spark plug ports in the cylinder head(s) can become stripped or missing when the spark plug is dislodged. The threads in cylinder heads may be replaced using “Lock-N-Stitch” aluminum inserts. Our technicians tell us thread replacement is performed when the vehicle is out of base warranty. Vehicles under base warranty receive a new cylinder head.

Engine Oil Leaks from Cylinder Head Area

Engine oil may leak externally from the cylinder head gasket. The gaskets were contaminated with metal debris from the factory – between the block and gasket and/or the head and gasket. To correct, the head gasket must be replaced and the mating surfaces on the cylinder head and block need to be inspected for chips or damage. In some cases the cylinder head will not be repairable and will need replacement.

See More Problems (5)

2007 Ford E-250 Questions

Cruise control works intermittently. (1 answer)

Sometimes I have to set the speed several times before it will hold speed (green light on dash stays on). Sometimes I will be driving with cruise on and it will shut off without touching brakes or buttons on steering wheel. Where can I check for loose connection? This problem has only started wit...

Doesn't want you to put gas in it. (1 answer)

My cargo van doesn't want to take gas when I'm pumping
you can only pump a dollar at a time. It will. shut off. I m not topping it off.

when i move off there is a " clunk" sound, then jumps into gear ?? (1 answer)

when i move off there is a " clunk" sound, then jumps into gear ??

See More Questions (4)

2007 Ford E-250 Recalls

Wheel Chair Lift Platform Cracks

The wheelchair lift platform may crack and separate from the wheelchair lift. Additionally, the link arms of the lifts may have pivot holes that are too large, allowing the bearings to move out of position. Either case could cause the platform to fall from the vehicle, possibly causing injury. Dealers will inspect the platform for cracks and replace any damaged parts free of charge to resolve the concern.

Wheel Chair Lift Platform May Fall From Lift

On wheel chair lift equipped vehicles, the lifts have folding link arms that may have pivot holes that are too big, allowing the bearings to move out of position. This can result in the lift platform falling from the vehicle. Dealers will inspect the link arms for damage or for displaced bearings. The platform will be inspected for cracks, and any damaged parts will be replaced free of charge to resolve the concern.

Wheel Chair Lift Platform May Fall From Lift

For vehicles modified for use with wheel chairs, the wheel chair platform side plates may crack, resulting in the platform separating from the wheel chair lift. Dealers will replace any platform that has started cracking, and will install supplemental platform support bumpers free of charge to resolve the concern.

See More Recalls (9)