2007 Dodge Ram 3500 Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2007 Dodge Ram 3500
2007 Dodge Ram 3500 Problems
Replacing a pressure solenoid valve in the transmission valve body may fix an issue where the transmission "hunts" between first and second gears. Our technicians report that customers sometimes describe this complaint as surging or bucking.
The thermostat may fail to close completely, causing the Check Engine Light to illuminate. This problem will prevent the engine from reaching normal operating temperature; a new thermostat should be installed.
If the engine does not crank (or cranks but won't start), the wireless control module (WCM) may have locked up. This is due to static discharge through the ignition key. A revised model should be installed, but simply disconnecting the negative terminal of the battery for thirty seconds will temporarily reset the module so you can start the car.
2007 Dodge Ram 3500 Questions
The exhaust reburn is something I'd like to get rid of and was told it was possible. Any suggestions?
All my lights work except the reverse lights and I've checked the fuses. All seems good. Is there another fuse I'm overlooking. Had them working, then nothing, all of a sudden. Thanks
In any gear (including neutral) but in park squeak goes away instantaneous. Also at any rmp no squeak in park. I have changed the belt, tensioner, water pump and idler pulley. They all seemed fine but most likely so i changed them. The a/c, alt, p/s all are fine as well and the pulleys are in ali...
2007 Dodge Ram 3500 Recalls
This limited regional recall is for vehicles currently registered or first sold in Florida, Puerto Rico, Hawaii and the U.S. Virgin Islands, and equipped with Takata-brand air bag inflators. Upon deployment the driver and/or passenger airbag inflator could rupture, increasing the risk of personal injury. Honda dealers will replace the affected airbag inflator modules to correct this concern.
The left and right tie rod assemblies are part of the front steering linkage, Certain trucks are being recalled because the left tie rod can break unexpectedly. This can result in loss of steering control. Dealers will inspect the steering linkage and install a new left tie rod assembly as necessary to correct this concern. This recall supersedes a previous recall, some vehicles repaired under the first recall may require an additional repair.
Certain vehicles may have been assembled with a left outer tie rod ball stud that may fracture; others may have received the affected tie rod assembly as a replacement part during normal service. This condition tends to occur during low speed parking lot type maneuvers when the driver is making a tight turn. This condition could result in a loss of directional stability in the left front wheel, increasing the risk of a crash. Dealers will inspect the tie rod ends, replace the left outer tie rod end as required, and perform a front end toe alignment as needed. The manufacturer has not yet provided an owner notification schedule. The Chrysler recall number is L16.
2007 Dodge Ram 3500 Reviews
my turn signals work but my hazard lights wont work. can somebody help please?