2000 Chevrolet Tahoe Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2000 Chevrolet Tahoe
Verified by mechanics, reported by drivers like you
Ask a mechanic in our community
Never overpay. Check prices with our estimator
2000 Chevrolet Tahoe ProblemsFuel Level Sensor Failure
It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.
The 4WD transfer case encoder motor position sensor or the selector switch may fail causing the service 4WD message to be displayed. Fault code(s) stored in the transfer case control module will be of assistance in determining the exact fault causing the message to be displayed.
One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.
2000 Chevrolet Tahoe QuestionsBattery dead while charging rear heater fan on when switch is off why?200 (1 answer)
While charging battery rear fan runs while switch is off and weird noise in radio
I have a 2000 Tahoe LT 4x4 with a trailer package. My existing radiator is 34" wide and definitely has a transmission oil cooler but I am not sure about the Engine oil cooler. How can I tell? Need to order new radiator. Thanks
when u take the key outta the ignition and open the doors everything stays on? How can I fix this???
2000 Chevrolet Tahoe RecallsRecall 05V379000
The courtesy lamps on affected running boards may overheat when exposed to moisture and road salt. Overheating may cause the lamps and boards to melt or start a fire. Dealers will replace the wiring harness for these running boards.
Two potential pinch points exist on the second row seats when the head restraints are folded rearward and the seat back is folded down. If a person were to insert their finger(s) into the pinch point, it could trap and pinch the finger(s) causing injury. Dealers will install protective covers over the pinch points. The recall began November 22, 2002.