2013 Chevrolet Suburban 1500 Repair and Maintenance

A guide to problems, costs, maintenance and repair for your 2013 Chevrolet Suburban 1500

Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
Get a Repair Estimate For Your 2013 Chevrolet Suburban 1500
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more

2013 Chevrolet Suburban 1500 Problems

Speedometer or Other Instrument Panel Gauge May Work Erratically

The speedometer or other instrument panel gauge may begin to work erratically at times. Our technicians tell us that the instrument cluster must be sent to a repair facility to correct this fault. The warranty has been extended on some of these units to 7 years or 70,000 miles.

Front/Rear Differential May Develop Noise Due to Worn Bearings

The front or rear differential may develop an abnormal noise due to worn bearings or another internal fault. Our technicians tell us that a complete overhaul of the affected differential is commonly necessary to correct this condition.

Reduced Power and Check Engine Light

The throttle position sensor (TPS) on the Chevrolet Suburban 1500 is known for failure which causes:

This issue is related to the throttle position sensor, and can be caused by faulty wiring to the TPS, bad connection at the TPS, or a failed TPS.

To correct this issue, the wiring harness, connector, and throttle position sensor must be inspected, tested, and/or replaced. The most common cause is a faulty TPS.

See More Problems (3)

2013 Chevrolet Suburban 1500 Recalls

Engine Stalls From Electrical Module Short

The chassis electrical module can short due to internal contamination. This can result in the vehicle stalling. Dealers will replace the chassis electronic module free of charge to resolve the concern.

Potential Failure of the Transmission Shift Interlock System

All late model vehicles are equipped with a "Shift interlock" system that prevents vehicles with and automatic transmission from being shifted out of the Park position under certain conditions. Some of these vehicles are being recalled because they may have been assembled with a broken park lock cable or a malformed steering column lock actuator gear. Failure of these components can allow the shifter to be moved out of the Park position with the ignition key removed or in the off position. This can cause the vehicle to roll away unexpectedly increasing the risk of injury or a crash. Dealers will inspect the recalled vehicles and replace the steering column as necessary.

 

 

See More Recalls (2)