2005 Chevrolet Corvette Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2005 Chevrolet Corvette
Verified by mechanics, reported by drivers like you
Ask a mechanic in our community
Never overpay. Check prices with our estimator
2005 Chevrolet Corvette ProblemsService Stability Message Due to Failed Steering Wheel Position Sensor
The steering wheel position sensor may fail, resulting in the service stability message being displayed.
Illumination of the Check Engine Light may be the result of a loose or worn gas cap.
It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.
2005 Chevrolet Corvette Questionsair bag light stay on to long (1 answer)
it feels like the switch isn't disengaging when I press the brake pedal. repeatedly pressing and releasing the brake pedal doesn't seem to work, but sometimes when I turn off the engine, open the door, close the door and restart the engine it works. Nothing seems to work all of the time.....
This will be the second time I have replaced the passenger seat belt because it will lock up and will not release. I have a 5 year old child and i was out of town and once again the seat belt locked and I had to drive 200 miles with a child and no seat belt. Any advice on how to fix this problem...
2005 Chevrolet Corvette RecallsLow Beam Headlighs
The underhood bussed electrical center (fuse box) can expand causing the low beam relay to flex. Over time this can cause the relay to fail, resulting in loss of low beam headlight operation. Loss of headlight operation can affect the drivers ability see and be seen, increasing the risk of a crash. Dealers will replace the underhood bussed electrical housing unit to correct this concern. 2008-2013 Chevrolet Corvettes will be covered under customer satisfaction program number 14203 for the same issue.
In certain cases, repeated movement of the steering column on vehicles equipped with tilt andtelescoping options may cause a signal interruption with the column. If this were to occur, the "service active handling system" message would be displayed. One or more of the brakes could apply, possibly causing the vehicle to pull to the left or right. Failure of the driver to react to the change in vehicle movement could result in a crash. Dealers will perform repairs necessary to correct this issue. This recall is expected to begin on April 30, 2010. The General Motors recall number is 10118.
The adhesive bonding the roof panel to its frame may separate. Partial separation could result in one or more of the following: snapping noise over bumps, wind noise, poor roof panel fit, roof panel movement when a door is closed, or a water leak. Total separation while the vehicle is in motion could result in personal injury or property damage. Dealers will install a new roof panel to correct this concern. This recall is expected to begin during April 2010. The General Motors recall number is 90230.