2010 Chevrolet Corvette ZR-1 Repair and Maintenance

A guide to problems, costs, maintenance and repair for your 2010 Chevrolet Corvette ZR-1

Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
Get a Repair Estimate For Your 2010 Chevrolet Corvette ZR-1
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more

2010 Chevrolet Corvette ZR-1 Problems

Flush brake fluid every 60,000 miles

Brake fluid can become dirty and may cause problems in the brake system; it should be flushed every 60,000 miles.

Reduced Power and Check Engine Light

The throttle position sensor (TPS) on the Chevrolet Corvette ZR-1 is notorious for failure which causes:

This issue is related to the throttle position sensor, and can be caused by faulty wiring to the TPS, bad connection at the TPS, or a failed TPS.

To correct this issue, the wiring harness, connector, and throttle position sensor must be inspected, tested, and/or replaced. The most common cause is a faulty TPS.

Check Engine Light Due to Loose or Worn Gas Cap

A loose or worn gas cap could be cause the Check Engine Light to illuminate.

See More Problems (5)

2010 Chevrolet Corvette ZR-1 Reviews

Rated
based on 1 customer reviews
Experiencing clanking rr tire area when turing into a graded drive...dealer can find no fault?? Concerned about future problems resulting from this unknown noise and safety concerns at high speeds...

See More Reviews (1)