1994 Chevrolet Beretta Repair and Maintenance

A guide to problems, costs, maintenance and repair for your 1994 Chevrolet Beretta

No_car
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
Get a Repair Estimate For Your 1994 Chevrolet Beretta
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more

1994 Chevrolet Beretta Problems

Fuel injectors can short-circuit

One or more of the fuel injectors may short out electrically causing a rough idle condition.

PCV Vacuum Hose Under Upper Intake Plenum May Crack

The PCV vacuum hose under the upper intake plenum may become brittle and crack causing an engine vacuum leak.

Car Won't Start Due to Ignition Coil/Crankshaft Position Sensor Failure

The ignition module or crankshaft position sensor may fail causing the engine to die and not restart. Diagnoses will be necessary to determine if the module or crank sensor is causing the no start condition.

See More Problems (17)

1994 Chevrolet Beretta Questions

Why does my Beretta shimmy and shake until about third gear and then drive fine? (1 answer)

All of the fluids are fine. I have noticed a wire hanging down but cannot tell where it goes though. Could that have something to do with it?

car wont start.. or try to turn at all (4 answers)

i replaced the ignition switch, swapped batterys, tested the starter, and checked all fuses. nothing happens. when i go to "start" the car... nothing. all you hear is the fuel injectors. no sound from the starter at all. all dash lights come on as they are soposed to, head lights are br...

Is there a way to reset the low coolant warning light? (1 answer)

Coolant system was just drained and reserviced. The coolant low level light will not go out. The sending unit appears to be an internal part of the reservior. Do I need a new reservior?

See More Questions (17)

1994 Chevrolet Beretta Recalls

Recall 94V176000
THE REINFORCEMENT PANEL THAT SERVES AS A LIFTPOINT FOR THE FRAME WAS OMITTED FROM THE RIGHT SIDE ROCKER ASSEMBLY OF THE FRAME THE VEHICLES DO NOT CONFORM TO THE REQUIREMENTS OF FMVSS NO. 208, "OCCUPANT CRASH PROTECTION."
Recall 93V157000
THE SUSPENSION SUPPORT ASSEMBLIES DO NOT MEET GENERAL MOTORS CORPORATION'S SPECIFICATION FOR WELD INTEGRITY AND THE AFFECTED WELD CAN FAIL CAUSING THE FRONT OF THE CONTROL ARM TO SEPARATE FROM THE SUSPENSION SUPPORT ASSEMBLY.

See More Recalls (2)

1994 Chevrolet Beretta Reviews

had my car for 4 years no problems yet. a nice car for young and old

See More Reviews (1)