1991 Chevrolet Beretta Repair and Maintenance

A guide to problems, costs, maintenance and repair for your 1991 Chevrolet Beretta

No_car_image
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
Get a Repair Estimate For Your 1991 Chevrolet Beretta
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more

1991 Chevrolet Beretta Problems

Windows Rattling and Scraping

The windows on the Chevrolet Beretta commonly lean in towards the cabin when they are rolled down, and a metal-on-glass rattle is heard with any vibration. As the problem advances, popping may be heard from the door as the window rolls up or down.

This issue is caused by failing window regulator rivets which no longer hold the window upright. This places undue strain on pads that prevent the window from contacting the metal door frame. After a short time, the pads inside the door wear out, allowing the window to rattle and become scratched in a vertical pattern.

To correct the rattling and popping noises, the window regulator rivets and pads must be replaced

Fuel injectors can short-circuit

One or more of the fuel injectors may short out electrically causing a rough idle condition.

Car Won't Start Due to Ignition Module/Crankshaft Position Sensor Failure

The ignition module or crankshaft position sensor may fail causing the engine to die and not restart. Diagnoses will be necessary to determine if the module or crank sensor is causing the no start condition.

See More Problems (19)

1991 Chevrolet Beretta Questions

my car was under the water and wont start (1 answer)

i check the battery but the ligt service engine soon dont come on when i try to start the car could be the ecm?

I wanna know why my engine is stalling on me. (1 answer)

The car will turn over and idle for like 30 seconds and then shut off. It also shuts off immediately when you touch the gas. I have replaced the crankshaft sensor, fuel filter, vacuum lines, spark plugs, wires, oil change, and have checked all the sensors. The INFL REST light is coming on. Thats...

wont start (1 answer)

I just replaced the crank position sensor. 2.2 4 cyl still wont start. turns over good - gas is coming out from throttle body fine - nice little mist - but no spark or sometimes a backfire type sound as its turning over. ?? Thanks for any advice. Bob

See More Questions (12)

1991 Chevrolet Beretta Recalls

Recall 91V083000
NUT ATTACHING STEERING WHEEL MAY NOT HAVE BEEN PROPERLY TIGHTENED DURING INSTALLATION.

See More Recalls (1)