2003 Chevrolet Avalanche 2500 Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2003 Chevrolet Avalanche 2500
Verified by mechanics, reported by drivers like you
Ask a mechanic in our community
Never overpay. Check prices with our estimator
2003 Chevrolet Avalanche 2500 Problems4WD Transfer Case Position Sensor/Selector Switch May Fail
The 4WD transfer case encoder motor position sensor or the selector switch may fail causing the service 4WD message to be displayed. Fault code(s) stored in the transfer case control module will be of assistance in determining the exact fault causing the message to be displayed.
The muffler heat shield may become loose on the muffler causing a rattle or popping noise. Our technicians tell us there is a kit available from GM to correct this problem.
Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
2003 Chevrolet Avalanche 2500 QuestionsMy truck is stuck in 4h (1 answer)
Put it in 4h to drive through some mud now I can't get it back into 2h. Have pushed the buttons both the 2h and auto, moving, in neutral, in drive everything... stuck in 4H and drives hard on the road.
as a cam sensor. replaced crank sensor, was told it could cause that also. Now it wont start at all. cam sensor discontinued and im packed up to go on vacation. isnt there some thing i can do to fix this thing. I'm desperate to say the least
my 2003 avalanche keeps going dead every few days i have put in a new battery and i am still having the same problems any ideas on how to fix this
2003 Chevrolet Avalanche 2500 RecallsRear Seat Belt for Smaller Passengers May Not Fit Correctly
The second row center seat belt routing may make it difficult to position correctly on smaller passengers. If the seat belt rides up to fit around the abdomen, the risk of internal injury is increased in a crash. Dealers will cut the guide loop, remove a portion of the loop, and the remaining sides should be folded over and secured with a retainer. The recall began July 21, 2005. The GM recall number is 05037.
The hydro-boost housing relief valve bore may be out of specification. The seal may fracture as a result, which may reduce braking assist and slightly increase the steering effort while braking. Under certain conditions, more braking effort will be required to stop the vehicle. Dealers will replace the hydro-boost relief valve. The recall began June 18, 2004. The GM recall number is 04004.