1992 Chevrolet 2500 Pickup Repair and Maintenance Costs
A guide to repairs, service, and maintenance costs for your 1992 Chevrolet 2500 Pickup
Never overpay. Check prices with our estimator
Verified by mechanics, reported by drivers like you
Ask a mechanic in our community
1992 Chevrolet 2500 Pickup ProblemsInside/Outside Door Handles May Break
The inside and outside door handles are prone to breaking.
The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Our technicians tell us that operating the engine with a coolant/oil mix can result in internal engine damage. Replacing the intake manifold gasket should correct these leaks.
The windshield wipers may not work intermittently due to a faulty wiper motor control board. Our technicians tell us that lightly taping on the wiper motor when the fault occurs should temporarily get the wipers working again. Some vehicles were recalled for this problem and some were not. You will need to check with your local dealer to find out if a specific vehicle was included.
1992 Chevrolet 2500 Pickup QuestionsWhat would cause sudden and complete electrical failure? (1 answer)
I started the truck, and after it ran for about a minute, it suddenly just shut down, completely. It is electrical, that much I know.I tried to restart, and was met with utter silence.No lights, no spark.. nothing. I am hoping it is as simple as a fuse, but have no idea where to check
fuel pump went out replaced it then the truck started then dies replaced it 2 more times did not work check then grounds wires replace every senor pcm time set fuel presure regulapr
truck runs good until you turn on the lights. It starts loosing power and dies within minutes. turn off the lights, starts up just like normal.
1992 Chevrolet 2500 Pickup RecallsSeat Bolts Loosen And Fracture
The bolts that secure the seat recliner to the seat frame may loosen, fatigue and fracture, causing the seat back to recline suddenly. Dealers will remove all foam and fabric sandwiched between the recliner and frame, install washers between them, and install new bolts, tightening them to a higher torque specification free of charge to resolve the concern.