2009 Cadillac Escalade Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2009 Cadillac Escalade
Never overpay. Check prices with our estimator
Verified by mechanics, reported by drivers like you
2009 Cadillac Escalade ProblemsPower Door Lock Actuators May Fail
The power door lock actuators may become slow to operate or stop working completely and require replacement.
The throttle position sensor (TPS) on the Cadillac Escalade is notorious for failure which causes:
- Check engine light
- Reduced Power message
- OBD trouble code P2135
This issue is related to the throttle position sensor, and can be caused by faulty wiring to the TPS, bad connection at the TPS, or a failed TPS.
To correct this issue, the wiring harness, connector, and throttle position sensor must be inspected, tested, and/or replaced. The most common cause is a faulty TPS.
One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.
2009 Cadillac Escalade QuestionsI would like a estimate for repair (3 answers)
How do you get the light on the driver side to turn off..the car wasn't in accident but seatbelt light is on dashboard
2009 Cadillac Escalade RecallsPassenger Frontal Air Bag Inflator Ruptures On Deployment
The passenger frontal air bag inflator may rupture on deployment, causing metal fragments to come through the air bag and injure occupants. Dealers will replace the passenger frontal air bag inflator free of charge to resolve the concern.
The heated washer module under the hood could overheat due to excessive current draw. Under certain conditions, this could result in an under hood fire. This previous recall attempt in 2008 to repair this concern did not have the expected success. Dealers will now permanently disable and remove the heated washer module to correct this concern. This recall is expected to begin on June 20, 2010.
The RTV seal on the fuel system control modules may allow water to enter into the module. Water in the module can cause a short, which may cause hard starting, a crank-no start condition, or stalling, and the Service Engine Soon light may come on. If the engine stalls unexpectedly, there is an increased risk of a crash. Dealers will replace the fuel system control module free of charge. The recall began on May 18, 2009. The GM recall number is 08411.