2011 Cadillac Escalade EXT Repair and Maintenance Costs
A guide to repairs, service, and maintenance costs for your 2011 Cadillac Escalade EXT
Never overpay. Check prices with our estimator
Ask a mechanic in our community
2011 Cadillac Escalade EXT ProblemsReduced Power and Check Engine Light
The throttle position sensor (TPS) on the Cadillac Escalade EXT is notorious for failure which causes:
- Check engine light
- Reduced Power message
- OBD trouble code P2135
This issue is related to the throttle position sensor, and can be caused by faulty wiring to the TPS, bad connection at the TPS, or a failed TPS.
To correct this issue, the wiring harness, connector, and throttle position sensor must be inspected, tested, and/or replaced. The most common cause is a faulty TPS.
2011 Cadillac Escalade EXT Questionsthe dash temp. gauge stays at 1/4 all the time if the eng. is cold or hot. (1 answer)
The dash temp. gauge never changes. It stays the same all the time if the key is on or off. eng. is cold or hot. Can this be fixed ? or can I just change the temp. gauge ? Or do I have to change the hold dash cluster?
2011 Cadillac Escalade EXT RecallsPassenger Frontal Air Bag Inflator Ruptures On Deployment
The passenger frontal air bag inflator may rupture on deployment, causing metal fragments to come through the air bag and injure occupants. Dealers will replace the passenger frontal air bag inflator free of charge to resolve the concern.
The ignition switch actuator can bind causing the ignition switch to stick in the "start" position. If this were to occur the actuator can unexpectedly release, cause the ignition switch to snap back into the "Accessory" position. This would cause the engine to turn off with an associated loss of brake and steering power assist. If these conditions were to lead to a crash the airbags may not deploy as expected. Dealers will inspect and replace the ignition lock housing as necessary to correct this concern.
The rear axle cross pin may break. The cross pin is an internal component of the rear differential, which is housed in the rear axle assembly. If the cross pin breaks, the rear axle may lock, which could result in loss of control and a crash. Dealers will install a new rear axle cross pin to correct this concern. This recall should begin no later than January 25, 2011. The General Motors number for this recall is 10426A.