1995 Cadillac DeVille Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 1995 Cadillac DeVille
Never overpay. Check prices with our estimator
Verified by mechanics, reported by drivers like you
Ask a mechanic in our community
1995 Cadillac DeVille ProblemsPower Window Regulators may Fail
One or more of the power window regulators (one in each door) may fail causing the window to fall into the door and not roll up.
One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.
The engine may develop oil leaks from the lower crankcase portion of the engine block. Our technicians tell us that the engine must be removed from the vehicle to properly repair this oil leak.
1995 Cadillac DeVille Questionswhat can be broken regards to power steering fluid leaking under neath the dash (1 answer)
leaking powersteering fluid under the driver dash bored inside the car
Have had my car 2weeks changed oil tranmisson fluid new break fluid stalled would not restart changed fuelpump and fuel filter still will not start getting gas tryed starter fluid will not start what am I missing engine light was on before stalled but not now
1995 Cadillac DeVille RecallsGM Recalls 1995-1997 Models Due to Fuel Rail and Return Line Leaks
GM has recalled 1995-1997 Cadillac Deville, Eldorado, Seville, and Oldsmobile Aurora vehicles because the fuel rail and fuel system return line may crack and leak fuel. In the presence of an ignition source, a fuel leak may result in a fire. Dealers will replace the fuel rail and return line.
Cadillac has recalled 1995 DeVille, Eldorado, and Seville vehicles because the air bags may deploy inadvertently. The air bag sensing and diagnostic module may experience water intrusion, which may cause the system to malfunction. Dealers will clean the exterior case of the sensing and diagnostic module (SDM) and apply a potting compound to the SDM case and electrical connector body.