2010 BMW 550i Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2010 BMW 550i
Never overpay. Check prices with our estimator
2010 BMW 550i ProblemsWater spill on navigation control module
I spilled water on the control module and now it's not responding. I'm hoping it will dry out but if not, I need part number if possible.
A creak or squeak can be heard from the top of the front or rear doors. This noise is most noticeable when the windows are fully up. The noise is caused by the decay of the flocking material on the door seals. New door seals, Teflon tape, special lube, or a combination of all of these may be needed to eliminate the noise.
2010 BMW 550i RecallsExterior Lighting Concern
Increased resistance at the electrical contact points may cause damage to the ground terminal and housing of the connector. This can result in an intermittent or permanent loss of one or more rear lamp functions (tail, brake, turn-signal, reverse). Intermittent light operation reduces the ability to warn other motorists of the driver's intentions, increasing the risk of a crash. Dealers will replace the rear lamp bulb carriers to correct this concern.
The insulated connector for the positive battery cable may have been incorrectly attached to the trunk floor panel, which can lead to a loosening of the bolt connection. Loosening of the connection can cause an increase in electrical resistance and overheating of the cable connection, which could lead to a fire, even when the vehicle is not in use. As a precaution, owners are advised to park outside until the remedy has been completed. Dealers will secure the battery bolt cable connection as necessary to correct this concern.
On vehicles equipped with an 8 or 12 cylinder turbocharged engine, the circuit board for the electric water pump may overheat. This could lead to smoldering of the pump and/or an electrical fire in the engine compartment. Dealers will replace the auxiliary water pump to correct this concern.