Car Won't Start Due to Ignition Module/Crankshaft Position Sensor Failure on Buick Regal

The ignition module or crankshaft position sensor may fail causing the engine to die and not restart. Diagnoses will be necessary to determine if the module or crank sensor is causing the no start condition.

RepairPal Verified
Average mileage: 143,327 (96,655–190,000)
Engines affected: 2.0L 4 Cylinder Turbo, 3.1L V6
5 model years affected: 1990, 1991, 1992, 1993, more2011
6 people reported this problem
2 people shared problem details
1992 Buick Regal- 3.1L V6190,000
Would stop running randomly, usually would start up again--finally stopped starting. Replaced crank position sensor & running good again.
1 person likes thisFlag inappropiate
2011 Buick Regal- 2.0L 4 Cylinder Turbo96,655
RANDOMLY MY CAR WILL NOT START AND I HAVE TO JUMP IT OFF WITH ANOTHER VEHICLE
Related Items:
The mass air flow or crankshaft position sensor may fail causing the engine to intermittently s...
after driving my car then coming to a complete stop and shuting car off, my car will not start back up until it cools off. my sensors were replaced and so was fuel filter. could it be the module se...
The crankshaft position sensor, ignition module, and/or powertrain control module (PCM) may fail resulting in illumination of the Check Engine Light with ignition system related fault codes stored ...

Related Content