1991 Mazda Protege Q&A

1991 Mazda Protege Question: car wont crank

It will start for a day or two. Then you will try to start it and all the lights come on but no click, no crank, nothing. Then the next day it will start right away. It has plenty of juice in the batte -
Answer 1
I suspect that the starter is failing. check that you have battery voltage at the big starter cable, and battery voltage at the smaller START wire at the starter when your assistant turns the key to START. If so, and the starter doesn't run, then it's faulty. -
Answer 2
I HAD THIS SAME ISSUE AND EVERYONE SAID IT WAS MY STARTER BUT I GOT AN SECOND OPPION AND I EXPLAINED THAT IT WOULNDT CRANK AND ALL THE LIGHTS WOULD COME ON BUT THERE WAS NO CLICKING SOUND. PLUS IT DIDNT DO IT EVERYDAY AND THEY FOUND THAT MY IGNITION SWITCH WAS WORN OUT ONCE REPLACED I HAD NO MORE ISSUES. HOPE THIS HELPS YOU. -
Answer 3
po 522 seneor price -
Related Items:
after car sits for a few hours it takes a long time to start,i smell fuel,and it sounds like it...
my car did crank at one point but it wont stay crunk it just cuts off
An electrically shorted air flow sensor can cause a crank-no start condition. Diagnosis may show that ignition spark is normal, and there are no trouble codes stored.
cranks but no spark,and fuel pump wont kick on.ive replaced the distributor,with another used on(car was running)....the crank positioning sensor reads .557ohms what could be the problem?
Theres fuel, spark compression and the timing Belt is good. The car cranks but wont start replaced the mass air flow sensor so thats out. After the car cranks it smells a lot like gas like if there...