Q&A

2004 Nissan Altima

Question: Car will not start

Question

bravo, 2.5L 4 Cylinder, Fort Lauderdale, FL, March 17, 2010, 11:44

 Rookie

do I need to have the ECM re programed? I changed Cam and Crank sensors but car will not start. no codes stored.

0 Answers

Answer It

Flag This

Follow this Question Unfollow this Question

• This question hasn't been answered yet. Answer It or share it on Facebook, Twitter or Email to get an answer.

• my car will not start it just turn over
  i put a coil on and it started for about ten minutes and cut off

  Q&A > Nissan > 1996 Nissan Altima

• My problem only 34,000 miles. The engine may crank but not start.
  Car did not start, On the third day It started, I drove it twice that day then on the third time it was back to not starting. Fuel system issue? Maybe a crank shaft sensor issue?

  Q&A > Nissan > 2005 Nissan Altima

• My car will start, i might make it to the corner and it will die...
  I can also be in the middle of turning, and it will die! It started with the car not starting, so i had my starter replaced, then same problem so i was told to start the car in neutral. Now my car ...

  Q&A > Nissan > 1993 Nissan Altima

• will start but wont stay running
  I have a replaced my fuel pump and filter and after that when i started up my car, my rmps would race high, i would have to press on the gas and it would go back to normal. now my car will not turn...

  Q&A > Nissan > 1993 Nissan Altima

• Car not starting when pushing button
  Recently the car began to not turn over when brake is pushed and start button pushed. The brake resists when pushed and no starting. It takes 10 - 20 atempts before it startsturns over. It just ...

  Q&A > Nissan > 2008 Nissan Altima