Cadillac Recalls

RepairPal Expert Overview:

The brake hoses may leak at the connection fittings to the front brake calipers. This can be caused by road salt and other road contaminants. The dealership will replace both front brake hose assemblies free of charge.

RepairPal Expert Overview:

A switch that automatically controls the operation of the roof panel is not correctly recessed and may be activated accidentally. Any objects or passengers in the open roof area under closure may be crushed or injured as a result. Dealers will replace the surrounding switch trim to recess the switch and guard against accidental operation.

RepairPal Expert Overview:

The ignition switch actuator can bind causing the ignition switch to stick in the "start" position. If this were to occur the actuator can unexpectedly release, cause the ignition switch to snap back into the "Accessory" position. This would cause the engine to turn off with an associated loss of brake and steering power assist. If these conditions were to lead to a crash the airbags may not deploy as expected. Dealers will inspect and replace the ignition lock housing as necessary to correct this concern.

RepairPal Expert Overview:

The chassis electrical module can short due to internal contamination. This can result in the vehicle stalling. Dealers will replace the chassis electronic module free of charge to resolve the concern.

RepairPal Expert Overview:

On the affected vehicles, the jam nut on the rear suspension toe adjuster link may not be tightened to the proper specification. A loose toe adjuster link could cause the vehicle to sway or wander at highway speeds and eventual failure of the link. Failure of the toe adjuster link will cause an abrupt change in the vehicle's alignment increasing the risk of a crash. Dealers will inspect the torque of both left and right rear toe link adjuster lock nuts, and replace the parts if there is evidence of damage or a loose link.

RepairPal Expert Overview:

Due to a potential problem with seatbelt pretensioners, front seat occupants may not be properly restrained in the event of a crash, increasing the risk of personal injury. Dealers will replace both front the driver's and the passenger's lap belt pretensioners to correct this concern. Remedy parts are not currently available, owners will be sent a notification when parts become available.

RepairPal Expert Overview:

The driver's and/or passenger's seat may suddenly drop to its lowest position because a bolt securing the height adjuster can fall out. This unexpected movement of the driver's seat could cause a distraction, increasing the risk of a crash. Dealers will replace the height adjuster bolts in both front seats to correct this concern.

RepairPal Expert Overview:

Due to an incomplete weld on the seat hook bracket assembly, the front seats in the affected vehicles may not stay secured in place. A seat that does not stay secured increases the risk of occupant injury in a vehicle crash. Dealers will inspect the lower seat track and replace it as necessary to correct this concern.

RepairPal Expert Overview:

The weight on the key ring and/or some other jarring event may cause the ignition switch to move out of the run position, turning off the engine and increasing the risk of a crash. In the event of a crash, if the key is not in the run position, the air bags may not deploy as expected. Dealers will provide two replacement key rings, and vehicles with slotted keys will receive key inserts to correct this concern. Note: Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key. The key fob (if applicable), should also be removed from the key ring.

 

RepairPal Expert Overview:

Excess weight on the key ring can cause the ignition switch to move out of the run position without warning, turning off the engine. This defect can also affect the safe operation of the airbag system. Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key. The key fob (if applicable), should also be removed from the key ring. Dealers will install two 13mm key rings and key insert into the vehicle's ignition keys to correct this concern.