1995 Cadillac Seville SLS Problem Reports

RepairPal Verified 1995 Cadillac Seville SLS Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

The crankshaft position sensor may fail causing the engine to stall intermittently, the Check Engine Light may or may not illuminate.

An intake manifold vacuum leak can develop from a variety of sources, often causing illumination of the Check Engine Light with codes P0171 & P0174 stored. Thorough diagnoses will be necessary to pinpoint the cause in order to make the correct repairs. A "smoke" machine is often used to isolate the cause of difficult to find vacuum leaks.

One or more heater & AC (HVAC) temperature and/or air delivery mode door actuator may fail, resulting in improper temperature or air delivery. If this occurs, fault code(s) should be stored in the HVAC control module which should assist in diagnoses.

The trunk pull down switch may fail causing the trunk lid not to close completely. Our technicians tell us that the failed switch can be replaced without changing the complete pull down motor assembly.

One or both transmission output shaft seals may leak. Our technicians tell us that worn bushings inside the transmission could be the cause of the damaged seals. Our technicians tell us that if a bushing is worn, excess play will be noted where the drive axle attaches to the transmission.

Overheating of the engine may cause the cylinder head to expand, severely straining the head bolts and damaging the threads in the engine block. This commonly results in a blown head gasket. Our technicians tell us the engine block threads must be repaired before the cylinder head is reinstalled.

The engine may develop an oil leak from the lower crankcase portion of the engine block. Our technicians tell us that the engine must be removed from the vehicle to properly repair this oil leak.

The electronic level ride system may not work properly; this may result in the rear of the vehicle riding too high or too low. Our technicians tell us that a height sensor or exhaust valve failure are common issues with this system. Proper diagnoses will be necessary to confirm the exact fault.

The anti-lock brake system (ABS) control module may fail causing the ABS light to illuminate. Failed modules should be replaced to restore ABS operation.

An automatic transmission fluid leak may develop from the rubber section of a transmission cooler line. In some cases the rubber section of hose can be replaced. In others, the complete cooler line must be replaced to correct this type of leak.

Problems with anti-theft systems using the raised-chip key can prevent the car from starting. The wires in the steering column to the ignition lock cylinder tend to break. The key and ignition lock cylinder should be replaced to correct this condition.

The parking brake may not release automatically due to a failed vacuum switch or actuator. Our technicians tell us that if vacuum is supplied to the actuator when the transmission is in gear, the vacuum switch is functioning and replacing the actuator should correct this concern.

The high-pressure power steering lines are known to leak.

The EGR valve may stick open, causing a rough idle and/or the Check Engine Light to illuminate.

The fuel pump may fail causing the engine to stall and not restart. Our technicians recommend replacing the fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.