An ignition coil may fail causing one of the cylinders to misfire. Each of the two banks of cylinders has its own coil assembly. If one ignition coil fails the coil assembly for the corresponding cylinder bank must be replaced.
Problems for specific Cadillac Seville years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Repairpal verified 2000 Cadillac Seville problems
Illumination of the Check Engine Light may be the result of a loose or worn gas cap.
An intake manifold vacuum leak can develop from a variety of sources, often causing illumination of the Check Engine Light with codes P0171 & P0174 stored. Thorough diagnoses will be necessary to pinpoint the cause in order to make the correct repairs. A "smoke" machine is often used to isolate the cause of difficult to find vacuum leaks.
One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.
The trunk pull down switch may fail causing the trunk lid not to close completely. Our technicians tell us that the failed switch can be replaced without changing the complete pull down motor assembly.
The torque converter clutch (TTC) may stop working due to an internal transmission failure. The Check Engine Light will illuminate if this occurs. Our technicians tell us the transmission will require dis-assembly to correct this concern.
The anti-lock brake system (ABS) control module may fail causing the ABS light to illuminate. Failed modules should be replaced to restore ABS operation.
The rubber section of an automatic transmission cooler line may develop a fluid leak . In some cases the leaking section of hose can be replaced. In others, the complete cooler line must be replaced to correct this concern.
The parking brake may not release automatically due to a failed vacuum switch or actuator. Our technicians tell us that if vacuum is supplied to the actuator when the transmission is in gear, the vacuum switch is functioning and replacing the actuator should correct this concern.
It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.