1991 Cadillac Seville Problems
RepairPal has identified the most common problems with the 1991 Cadillac Seville as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
The trunk pull down switch may fail causing the trunk lid not to close completely. Our technicians tell us that the failed switch can be replaced without changing the complete pull down motor assembly.
One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.
The parking brake may not release automatically due to a failed vacuum switch or actuator. Our technicians tell us that if vacuum is supplied to the actuator when the transmission is in gear, the vacuum switch is functioning and replacing the actuator should correct this concern.
Problems with the anti-theft systems using the raised-chip key can prevent the car from starting. The wires in the steering column to the ignition lock cylinder tend to break. The the key and ignition lock cylinder must be replaced to correct this condition.
The spark plugs should be replaced every 30,000 miles and the spark plug boots should be checked for hot spots and cracks.
Excessive carbon build up in the engine combustion chambers may be the cause of a smog check failure due to excess NOx emissions. A "top engine" decoarbonization cleaning procedure will commonly correct this concern.
The rubber section of an automatic transmission cooler line may develop a fluid leak . In some cases the leaking section of hose can be replaced. In others, the complete cooler line must be replaced to correct this concern.
The air conditioning compressor may become noisy or develop a refrigeration leak, requiring replacement.
The anti-lock brake system (ABS) control module may fail causing the ABS light to illuminate. Failed modules should be replaced to restore ABS operation.
Fuel injectors can short-circuit electrically causing a rougher than normal idle and reduced performance.
A coolant leak may develop from the water pump. The engine may overheat as a result of the coolant loss. A leaking water pump should be replaced.
This powertrain control module (PCM) may develop a fault with its electrical ground location at the front of the engine block near the starter motor.
The alternator may fail causing the battery to go dead, or an abnormal noise may develop. The dash warning light may or may not illuminate. A failed alternator will require replacement.