Problem Reports

Failure of the crankshaft position sensor, ignition control module, or powertrain control module (PCM) may cause the Check Engine Light to illuminate.

Do to a low or erratic voltage condition, the fuel gauge needle may "jump" around and become stuck on the back side of the "stop" below the "empty" indicator. This does not mean the gauge is broken. If the gauge cover is removed and the needle is gently moved back around to the correct side of the pin, the gauge will again function normally. When the needle is moved back to the correct position, the electrical problem that caused the needle to jump in the first place must be corrected or the needle may jump around again. The most common problems that cause this condition are a weak battery or corrosion on the battery cable ends.

The outer tie rod ends on the steering linkage may wear causing excessive free play in the steering and uneven tire wear. If the worn tie rod ends are replaced, the wheel alignment should be checked and adjusted as necessary.

The intake manifold gasket may develop external engine oil and/or coolant leak. The intake manifold will need to be removed and the gasket replaced to correct this issue.

The mode and temperature door actuators may fail causing improper air flow or temperature output from the heating and AC (HVAC) system.

The rubber section of an automatic transmission cooler line may develop a fluid leak . In some cases the leaking section of hose can be replaced. In others, the complete cooler line must be replaced to correct this concern.

It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.