An ignition coil may fail causing one of the cylinders to misfire. Each of the two banks of cylinders has its own coil assembly. If one ignition coil fails the coil assembly for the corresponding cylinder bank must be replaced.
2006 Buick Lucerne Problem Reports
Newest 2006 Buick Lucerne Problem Reports
An intake manifold vacuum leak can develop from a variety of sources, often causing illumination of the Check Engine Light with codes P0171 & P0174 stored. Thorough diagnoses will be necessary to pinpoint the cause in order to make the correct repairs. A "smoke" machine is often used to isolate the cause of difficult to find vacuum leaks.
The steering may develop a clunk type noise from the upper intermediate steering shaft. Our technicians tell us that you should check with your local GM dealer to find out what the latest repair is for this condition.
A Loose or worn gas cap may cause Check Engine Light to illuminate.
Broken motor mount at 33000 miles , repaired at dealer.
Overheating of the engine may cause the cylinder head to expand, severely straining the head bolts and damaging the threads in the engine block. This commonly results in a blown head gasket. Our technicians tell us the engine block threads must be repaired before the cylinder head is reinstalled.
The engine may develop an oil leak from the lower crankcase portion of the engine block. Our technicians tell us that the engine must be removed from the vehicle to properly repair this oil leak.
The front struts may show signs of wear, or be excessively bouncy ride at freeway speeds. This may begin to occur at around 75,000 miles.
The fuel pump may fail causing the engine to stall and not restart.
The steering wheel position sensor may fail, resulting in the service stability message being displayed.
The water pump and/or the plastic side tanks on the radiator may leak causing a loss of coolant. The engine may overheat due to coolant loss. Continued coolant loss after external leaks have been repaired could indicate a blown head gasket.
An engine oil leak may develop from the front crankshaft seal. Our technicians tell us a revised front crankshaft seal is available to correct this concern.