2002 Buick LeSabre Problems
RepairPal has identified the most common problems with the 2002 Buick LeSabre as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
The transmission pressure control solenoid may fail causing erratic shifting. Our technicians tell us that partial dis-assembly of the transmission is necessary to replace a failed pressure control solenoid.
It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.
The front struts may show signs of wear, or be excessively bouncy ride at freeway speeds. This may begin to occur at around 75,000 miles.
Problems with the anti-theft systems using the raised-chip key can prevent the car from starting. The wires in the steering column to the ignition lock cylinder tend to break. The the key and ignition lock cylinder must be replaced to correct this condition.
One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.
Illumination of the Check Engine Light may be the result of a loose or worn gas cap.
The upper intake manifold may develop an internal coolant leak causing one or more cylinders to fill with coolant. This can cause the engine to "hydro-lock" and not turn over. Removing the spark plugs will allow the engine to turn over pushing the coolant out of the spark plug holes. Replacing the upper intake plenum and gasket is commonly required to correct this condition.
The engine can be very difficult to start after this problem has been repaired, it can be helpful to clear as much of the coolant from the intake manifold and cylinders as possible before reassembling the intake manifold.