Problems for specific Buick LeSabre years:
Problem Reports
Problem with your car? See what our experts say or submit your own.
1996 Buick LeSabre Problems
Loss of power steering fluid from steering rack failure
The steering rack may fail causing a loss of power steering fluid as a result the steering may become hard to turn.
Engine Stalling Due to Mass Air Flow/Crankshift Position Sensor Failure
The mass air flow or crankshaft position sensor may fail causing the engine to stall intermittently. Proper diagnoses will be necessary to determine the cause of any stalling condition.
Check Engine Light Due to Gas Cap Issue
Illumination of the Check Engine Light may be the result of a loose or worn gas cap.
Wear In Outer Tie Rod Ends Can Cause Steering Problems
The outer tie rod ends on the steering linkage may wear causing excessive free play in the steering and uneven tire wear. If the worn tie rod ends are replaced, the wheel alignment should be checked and adjusted as necessary.
Engine Overheating Due to Water Pump Leak
The water pump may develop a coolant leak resulting in an engine overheating condition.
Engine Oil Leak From Intake Manifold Gasket
The intake manifold gasket can develop external engine oil leaks. The intake manifold will need to be removed and the gaskets replaced to correct this issue.
Engine Won't Turn Over Due to Coolant Leak From Upper Intake Manifold
The upper intake manifold may develop an internal coolant leak causing one or more cylinders to fill with coolant. This can cause the engine to "hydro-lock" and not turn over. Removing the spark plugs will allow the engine to turn over pushing the coolant out of the spark plug holes. Replacing the upper intake plenum and gasket is commonly required to correct this condition.
The engine can be very difficult to start after this problem has been repaired, it can be helpful to clear as much of the coolant from the intake manifold and cylinders as possible before reassembling the intake manifold.
Improper HVAC Temperature and/or Air Delivery Due to Failed Mode Door Actuator
One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.
Transmission Fluid Leak From Cooler Line
The rubber section of an automatic transmission cooler line may develop a fluid leak . In some cases the leaking section of hose can be replaced. In others, the complete cooler line must be replaced to correct this concern.
Car Won't Start and Security Light is On
Problems with the anti-theft systems using the raised-chip key can prevent the car from starting. The wires in the steering column to the ignition lock cylinder tend to break. The the key and ignition lock cylinder must be replaced to correct this condition.
High Pressure Power Steering Hose Can Leak Fluid
The high pressure power steering hose will commonly leak fluid; it should be replaced.
Erratic Fuel Gauge Operation
It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.
Poor Ride/Handling Due to Worn Suspension Struts
The front struts may show signs of wear, or be excessively bouncy ride at freeway speeds. This may begin to occur at around 75,000 miles.
The Fuel Pump May Fail Causing the Engine to Stall or Crank Over But Not Start
The fuel pump can fail causing the engine to stall and not restart. Our technicians highly recommend to replace your fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.
ABS light due to pressure modulator valve assembly failure
-
Verified
Quality Work -
Guaranteed
Fair Prices -
Happy
Customers