braking system on 1996 Dodge Ram 1500

i have a 1996 dodge ram 1500 4x4 and I noticed that my brake pedal was getting down a bit, I replaced the front brake pads and then I noticed that I had a broken brake line to the rear. I replaced the line and the rear brade shoes, still no brake pedal, I then replaced the master cylinder, breed all the lines and the master cylinder, still no brake pedal. Now I'm lost. What do I check next?

by in Augusta, MI on October 04, 2009
1 answer
ANSWER by on October 09, 2009
I would closely inspect all of your brake components for leakage, including your rear wheel cylinders. You need to check your ABS system for codes. Then you need to really bleed out your system. You may need to put your brake system in a special bleeding mode as well.
Related Items:
i have a caliper grabbing the rotor on the drivers side,with out putting the brakes on .i have put three calipers on and it still doing it what could it is not releasing all the way like it s...
If I have two different sized tires on the front and back wil that effect my abs braking system?
Driving down the road and my pedal went down to the floor pumped up and get a little pedal thought master cylinder was bad replaced it bled brakes motor off good pedal start motor petal goes to flo...
2004 dodge ram 1500 4.7 liter quad cab 2 wheel drive. replaced front pads , calipers and rotors. have bled the system for 2 hours and no brakes? tried every trick i know and no results. pedal gets ...
My speedometer quit working and my brake light and abs light stays on.I have checked the gound wire and all other guages are working brakes seam to work fine. please help.

Related Content