Chevrolet » S10 Blazer » 1992 Chevrolet S10 Blazer » Questions

Q&A

Ask Your Question

1992 Chevrolet S10 Blazer

 

Question: Brake problems?

Question

ray.d919, Wendell, NC, October 11, 2012, 00:29
 Rookie

I have noticed that when i drive the my blazer, i am having to put the brake pedal to the floor board in order for it to start slowing down? What could the problem be?

3 Answers
Answer It
Flag This

  • Answer #1

    goodguy October 11, 2012, 05:17
     Master

    check brake fluid if its low you probably have a leak somwhere if you cant see anything on the ground then pull the back wheels and check wheel cylinders for leaks and adjust the brakes

    Reply
    Flag This

  • Answer #2

    Greg's Orange Auto (8442 Answers) , Orange, CA - (714) 361-9355
    globalhelper October 11, 2012, 06:23
     Master

    are you adding alot of brk fluid? you could have a fluid leak at any wheel or master cyl ck that 1st. your brk booster could be going out if pedal is hard but has no stopping pwr

    Reply
    Flag This

  • Answer #3

    pushrod October 11, 2012, 06:54
     Master

    CHECK BRAKE FLUID IF FULL REPLACE MASTER CYLINDER.

    Reply
    Flag This
Related Items:
  • ABS Light Due to Brake System Control Unit Failure
    The Anti-lock brake system (ABS) control unit may fail internally causing the ABS warning light to illuminate.

    Common Problems > Chevrolet S10 Blazer

  • Why does only one front brake get really hot?
    I recently replaced caliper and pads also bled the brakes twice but I am still having my passenger front brake/rim heat up beyond touch i have to wait for them to cool down before working on them?

    Q&A > Chevrolet > 1990 Chevrolet S10 Blazer

  • What could be causing my front drivers side brake to keep locking? It's only the
    We have replaced calipers, rotor, Master cylinder, brake line, pads. Still locks up. Disconnect...

    Q&A > Chevrolet > 1993 Chevrolet S10 Blazer

  • brakes are stiff and won't stop when pressed
    When you push on brakes they won't go down it's stiff and the car won't stop easly. I was told it could be two things brake booster or master brake cylinder

    Q&A > Chevrolet > 1994 Chevrolet S10 Blazer

  • need help
    I have a 1989 Chevrolet s10 4x4 blazer, it has a 4.3 TBI engine and 700 r 4 tranny. A couple weeks ago I was driving and went to use the right turn signal and the gas guage started to malfunction a...

    Q&A > Chevrolet > 1990 Chevrolet S10 Blazer

Answer Ranks

This week's top 10

1 globalhelper 6 csubak30
2 pushrod 7 FREDDY BLUE
3 ziptie12 8 gearhead89
4 ChevyASE 9 ebans777
5 wenyan 10 tdtoolbox