In a crash that deploys the driver's front air bag, the inflator of the air bag can rupture, causing metal debris to strike vehicle occupants. Dealers will replace the front driver's air bag module free of charge to correct the concern.
The fuel pump may fail due to improper nickel plating during manufacturing. This can cause the engine to stall while driving. The dealership will replace the fuel pump free of charge to correct the problem.
These vehicles use a vacuum pump to supply power assist to the braking system. Due to insufficient lubrication this vacuum pump may fail. Failure of the brake vacuum pump would result in a reduction in braking power that could increase the risk of a crash. In order to correct this concern, dealers will install a locking ring in the camshaft to retain the camshaft seal disk in the proper location. This will ensure proper oiling of the vacuum pump. Note: This recall is an expansion of an earlier recall.
Upon deployment the passenger airbag inflator could rupture, increasing the risk of personal injury. BMW dealers will replace the affected airbag inflator modules to correct this concern.
This limited regional recall is for vehicles currently registered or first sold in Florida, Puerto Rico, Hawaii and the U.S. Virgin Islands, and equipped with Takata-brand air bag inflators. Upon deployment the driver and/or passenger airbag inflator could rupture, increasing the risk of personal injury. BMW dealers will replace the affected airbag inflator modules to correct this concern.
The front passenger seat contains a mat that determines the presence and size of a seat occupant. This input to the airbag controller helps to determine if and how forcefully the passenger airbag should deploy in the event of a crash. The detection mat can develop cracks and fail. If this were to occur, the airbag would not deploy as expected, increasing the risk of personal injury. Dealers will repair the occupant detection mat to eliminate the possibility it may crack. Additionally certain vehicles will receive and extended warranty on the front passenger seat occupant detection mat.
These vehicles use a vacuum pump to supply power assist for the braking system. The vacuum pump can fail unexpectedly due to insufficient lubrication. This would reduce braking efficiency, increasing the risk of a crash. Dealers will make modifications to allow for proper lubrication of the vacuum pump in order to correct this concern.
Increased resistance at the electrical contact points may cause damage to the ground terminal and housing of the connector. This can result in an intermittent or permanent loss of one or more rear lamp functions (tail, brake, turn-signal, reverse). Intermittent light operation reduces the ability to warn other motorists of the driver's intentions, increasing the risk of a crash. Dealers will replace the rear lamp bulb carriers to correct this concern.
The fuel filter on vehicles with a diesel engine is equipped with an electric heater to warm the diesel fuel in cold climate conditions. This heater could experience and electrical overload and fail to turn off as designed. Having the fuel heater stay on while the ignition is off could result in a dead battery. The heater could also overheat and potentially cause and electrical fire. Dealers will replace the diesel fuel filter heater on affected vehicles to complete this recall.
Airbags use a chemical reaction contained in an inflator module to create the pressure necessary to inflate the bags when deployment is required. These vehicles are being recalled because the front passenger airbag inflator may produce excessive internal pressure when deployed. As a result, the inflator module could rupture, causing metal fragments to strike vehicle occupants. Dealers will inspect and replace any defective passenger front airbag inflator modules found.