Q&A

1995 Ford Explorer

Question: bleeding the clutch system

Question

bodadeezy, Everett, WA, November 20, 2010, 16:03

 Rookie

i replaced the clutch and now am having trouble bleeding it i have had someone pump the pedal then loosened the bleeder valve several times but it has'nt got better HELP

2 Answers

Answer It

Flag This

Follow this Question Unfollow this Question

• Answer #1

  delane 72 garage and body shop November 20, 2010, 18:57
  

   Master

  did you replace slave cylinder in trans
  Flag This
  Like0
• Reply

  bodadeezy, November 21, 2010, 00:26
  

   Rookie

  no but the reason i put a new clutch in was the tranny would not go into third the synchro's were bad and the pressure plate and disc were worn i didnt have problems with the slave cylinder
  Reply
  Flag This
• Answer #2

  todays tech November 21, 2010, 09:26
  

   Journeyman

  Keep trying ford hydraulics can be difficult to bleed, pump pump and pump. You may try putting a vacuum on the master cylinder and sucking the air out of the top.
  Reply
  Flag This
  Like0

• bleeding clutch
  how do i remove clutch master cylinder

  Q&A > Ford > 1995 Ford Explorer

• Clutch not shifting when driven for a while.
  So its been happening for a while but has never concerned me that much. When I drive me vehicle from up the mountain down, say 45 minutes worth of driving. My clutch will almost refuse to go into...

  Q&A > Ford > 1994 Ford Explorer

• no clutch pressure
  is there a way to tell if the slave cylinder is bad? i replaced the pressure plate disc ,throw out bearing and clutch master cylinder. i have bench bled the master cylinder and pumped and bled the ...

  Q&A > Ford > 1995 Ford Explorer

• hydraulic clutch
  trying to bleed the system i took the quick connect line off and pushed the stop ball in and fluid came out just fine, then i opened the bleeder valve and a steady stream came from there i closed ...

  Q&A > Ford > 1995 Ford Explorer