axle replacement on 2006 Dodge Ram 2500

how do i pull the front axle out

by in Eureka, CA on September 11, 2009
1 answer
ANSWER by on September 11, 2009
Open the half shaft nut where it protrudes through the outer spindle/hub assembly, remove the caliper and rotor, remove the four bolts at the back of the steering knuckle/hub that retain the bearing in the hub. Axle nut torque is 132 ft/lb.The axle will be able to be with drawn from the front differential once the outer portion of the hub is disassembled.
Related Items:
how do i take out the front axle driver side
ocaasionally it will shift on it own but most of the time I had to put it into neutral then back into drive..i replaced the speed sensor and the abs sensor on the rear axle still no change , then i...
I have a 1998 ram 2500 the speedometer doesn't work until the truck hits 25 mph and the abs and...
i have a 2005 dodge ram 2500 i broke the spider gears in the front axle i did not have the money to fix it at the time but i do now and need to get it done with the bad weather i pulle...
im needing to replace the driver side axle seal. how long ca n i drive it before i replace it . it is leaking grease.

Related Content