2009 Audi A4 Problems
RepairPal has identified the most common problems with the 2009 Audi A4 as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
2.0L turbo charged engines may develop a hesitation on acceleration and/or illumination of the Check Engine Light due to a failed high pressure fuel pump or a worn camshaft follower or camshaft. Our technicians tell us that whenever the high pressure fuel pump is replaced the camshaft and the follower should be checked for wear. The camshaft lobe pushes on the follower to operate the high pressure fuel pump. Frequent inspection of the cam and high pressure fuel pump can prevent cam failure.
Popping sounds from the rear of the vehicle may be heard moments after starting the engine, or when slowing to a stop. This noise is from the leak detection pump filling the fuel tank with air, and releasing to retest the system when it finds a fault. The sequence of faults identifying this issue are as follows:
- Succession of loud pops from rear of vehicle
- Pops go away, and fuel economy decreases
- Check engine light illuminates
- OBD trouble code P2404 and/or P0441 is stored
- Engine will not start after refueling (must crank for over 30 seconds)
- Vibration when slowing to a stop
The cause is a valve which is mounted on the front of the intake manifold, commonly called the N80 valve, or EVAP system purge valve. The valve is designed to open under specific circumstances, but a worn valve will remain open at all times, preventing the pressurization of the fuel tank.
Correction of the issue is to replace the N80 valve with the latest revision.
The 2006-2017 Audi A4 uses the 2.0FSI, 2.0TFSI, and 3.2FSI direct injection engines. These engines are subject to carbon buildup in the intake system which can cause power loss, OBD codes and a check engine light, and a rough idle. In normal engines, the engine is cleaned by the gasoline flowing through the injectors and into the intake system, however, the A4 uses direct injection so gasoline does not flow through common carbon buildup areas.
The solution is to remove the intake manifold and professionally clean the intake manifold, intake ports on the cylinder head, and the intake valves. This may need to be done in as few as 20,000 miles.
Clogged drains can allow rainwater to accumulate in the plenum tray (at the base of the windshield). The water may leak into the vehicle's interior, brake booster, or electrical components, which can lead to major problems. Our technicians recommend keeping the tray clear of leaves, pine needles, and other debris.
The Cabriolet convertible top mechanism can fail due to hydraulic fluid leaks. The fluid reservoir is a common failure.
Premature wear in various multi-link suspension components can cause noises that are difficult to diagnose. Worn suspension parts can also cause uneven tire wear and create steering alignment problems.