Close

Acura Service Light Reset

Acura

Anti-Lock Brake System Warning Lamp

RSX & TSX

The Anti-Lock warning lamp is used to warn of a system fault. The lamp monitors the condition of the anti-lock brake system. It will be lit during engine start-up, but should go off when the self-diagnostic system determines that the system is operating properly. If the lamp remains lit, a fault in the anti-lock brake system is indicated. After diagnosis and repair of the system, the lamp may be turned off.

With ignition switch in the Off position connect a suitable scan tool to the DLC located under driver side of instrument panel next to accelerator pedal.Place the ignition switch in the On position and follow the scan tool instructions to clear the DTCs.


Acura

Variable Torque Management 4WD (VTM-4) System Warning Lamp

2003-06 MDX

The VTM-4 warning lamp is used to warn of a system fault. The lamp monitors the condition of the Variable Torque Management system. It will be lit during engine start-up, but should go off when the self-diagnostic system determines that the system is operating properly. If the indicator blinks while driving, the vehicle can be pulled to the side of the road. Place transmission in Park and idle engine until the VTM-4 lamp turns Off. If the lamp remains lit, or comes on steady while driving a fault in the VTM-4 system is indicated. After diagnosis and repair of the system, the lamp may be turned off.

With ignition switch in the Off position connect a suitable scan tool to the DLC located under the lefthand side of instrument panel.Place the ignition switch in the On position and follow the scan tool instructions to clear the DTCs.



Acura

Maintenance Required Lamp

RSX

For the first 8000 miles the lamp will blink for 2 seconds each time the ignition is turned On. At 8000 to 10,000 miles the lamp will stay lit when the ignition is turned On. After performing the required maintenance, reset the lamp by proceeding as follows:

Press and hold SELECT/RESET button on righthand side of gauge assembly. Turn ignition On and continue to hold button for approximately 10 seconds until lamp resets.

 

acura reset light