Geo Prizm Problem Report

Geo Prizm ABS Warning Light Due to Failed Wheel Speed Sensor

(8 reports)

At higher mileages, an anti-lock brake system wheel speed sensor may wear out and illuminate the ABS warning light. It is recommended to replace the sensor with a factory part and be sure to clean all rust and debris from the mounting area because the mounting distance is critical. Failure to do so may result in the new sensor setting false trouble codes. 

abs light is on and and abs wire snaped -
Related Items:
Cleared code by disconnecting negative battery terminal,but after short time coe shows back up.
It had a low knocking noise, the faster I sped up the noise got louder. It just started today D...
1995 Geo Prizm, 193000 miles and it cuts out at 2700 rpm and above. Can accelerate through it...
I have a 1994 Geo Prizm and after the car has warmed up the motor will stall when you try to accelerate from a dead stop. I have changed the fuel filter, spark plugs and wires, throttle position se...
my abs light stay on

Related Content