I have a 1998 Plymouth Voyager, 3.3 engine and 198,600 miles on it. My driver's side cv transaxle broke in 2. I had to remove the brake line and caliper in order to put in the new transaxle. I bled driver's side brake. Started car and ABS light went on and is staying on. Can anyone please let me know how to fix problem? gg1328
ABS light stays on on 1998 Plymouth Voyager
by gg1328 in Albrightsville, PA on June 04, 2011
ANSWER by Superbob on June 04, 2011
There's something wrong with the ABS system, you may or may not have caused it. The ABS light indicates that the computer has detected a malfunction in the ABS system and has diagnostic codes and data stored which would be essential in diagnosing the problem. A technician with a scanner can access the diagnostic codes and data and then be able to give you a diagnosis. Unless the brake line was damaged, I don't think I'd have disconnected it to replace the drive axle, I'd have disconnected the caliper from the front suspension and hung it alongside on a piece of wire so as not to put tension the the rubber line. If you want to find a Plymouth specialist, here's our directory link for you: https://repairpal.com/directory?address=18210&car_brand_names=Plymouth
Brakes are wearing out in just a couple thousand miles,sometimes the brake pedal is low then you tap it with your foot and it comes back up.There is no abs light on ,how could i test the booster
A yellow anti-lock brake system (ABS) warning light may remain illuminated. If a wheel speed sensor fault is discovered, sensor connectors should be inspected. Damaged or spread terminals must be r...
Just resoldered cracked solder joints on instrument panel circuit board which fixed my "no gauges" problem. Now the speedo and tach are inaccurate.I did an onboard diagnostic test and all gauges we...