Car Problem Reports

Chevrolet Blazer ABS Light Due to Brake System Control Unit Failure

 
Chevrolet Blazer Problem
17 Reports
Me Too
Edit

Model Years Affected: 1994, 1995, 1996, 1997, 1998, 2000, 2001, 2003

Average Mileage: 146,912 mi (16,900 mi - 304,600 mi)

Verified

The Anti-lock brake system (ABS) control unit may fail internally causing the ABS warning light to illuminate.

  • Visitor, , 157,000 mi

    The ABS light comes on while driving. Sometime the ABS will kick on for no reason. I will be coming to a stop on a dry paved road and boom the ABS kick on. I beleive it is on one side only cause the vehicle will pull very hard to one side. The problem has no been addressed yet but I will be taking a lok at it shortly. IF any one else has had this problem and fixed it please let me know.

    Flag This
  • abs light stays on I unplugged the sensor light went off

    Flag This
  •  Rookie

    abs light on and service engine soon light on.service engine soon light goes on and off while engine is running

    Flag This
  • About a 9 months ago my ABS and Break light started coming on and would turn off on it's own. I took my Blazer in for some other repairs and had them take a look at the ABS sensors. They told me the sensors were fine and the breaks work just fine. It appeared to the related to the warning lights, the computer was reporting a problem that was not there. To fix it they needed to rebuild a part (don't remember what part), he said it would take a few days and would cost about $500.00 (If I had the dealer repair it the cost would be more than $1500.00). Since the breaks were working fine and I did not have the money to fix it I decided to let it go. I am ready to have it fixed now but wanted to know more about the problem. I wonder why this issue has not been recalled.

    Flag This
  • Visitor, , 179,800 mi

    brakes wont work at all

    Flag This
  • Intermittent abs warning light...ignoring it at present.

    Flag This
  • And and brake light stays on

    Flag This
  • The ABS light has always been on since I bought the car 3yrs ago. No matter how many times I take it to my mechanic, cannot get it to shut off.

    Flag This
  • Visitor, , 123,000 mi

    Anti-Brake module EBCM, internal solder points on IC board break away from points of contact due to poor manufacturing standards. This results in intermittent ABS & Brake light illumination on dashboard. Solution is to replace module or repair by (carefully) dis-assembling the unit, re-soldering all relay contact points on the bottom of the IC board. The repair method worked for me.

    Flag This
  • Visitor, , 16,900 mi

    01 blazer LT 4x4 brake and abs light on and off temporary solution, i unplugged brake pump sensor, turnned off.

    Flag This
+ See more reports
Ask a Question