abs brakes on 2002 Cadillac Escalade

i just recentley replaced the rear brakes and blead the system, but sometime the abs engages and the front pads are fine. Do you have any ideas?

by in Spring Grove, IL on October 02, 2009
1 answer 2 comments
ANSWER by on October 26, 2009
Did you find a solution to this problem? Was it related to the brake job? Did you check to see if there were any codes stored in the ABS module?
COMMENT by on October 26, 2009
I figured out what the problem was. There was some dirt inside the wheel bering, where the abs sensor plugs into. No matter how much you try to clean it out, there will always be some in there. The best thing to do is change the wheel bering, the come with the sensors already installed. Hope this helps somebody, with their problem.
COMMENT by on October 27, 2009
Thanks for the update, I believe this will help someone out there. Are these the front wheel bearings you are talking about?
Related Items:
The anti-lock brake system (ABS) front wheel speed sensors are prone to failure. When a sensor...
The anti-lock brake system (ABS) pump may stay running after the ignition is turned off causing the battery to go dead. Our technicians tell us that the ABS control module should be replaced to cor...
A poor electrical ground under the battery tray may cause the ABS warning light to illuminate. Our technicians tell us that cleaning and properly securing this ground and also the main ABS ground ...
10 seconds after car is started abs & parking brake lights come on

Related Content