2004 ford escape v6 3.0 on 2004 Ford Escape

is there any way to static check fan motors off of car but still in fan enclosure. it has a 3 pin connector and i know they controlled by engine temp. would like to make sure they are good before installing radiator. thanks perry

by in Marion, NC on July 07, 2011
1 answer
ANSWER by on July 07, 2011
I would use a 12 volt source, like a battery. There is going to be 1 ground wire and then a low speed wire and a high speed wire. Put the negative lead on to the ground side, which is typically black or brown and then try one of the other 2 with the positive lead. BE CAREFUL, so you do not cut your fingers.
Related Items:
there are two flanges connecting lines from engine compartment to condenser with one stud and nut each flange. are these an inner o-ring seal or metal to metal seal or gasket? i dont know if new co...
    The common problem for ignition misfires are ignition coils going bad. Replacement of the bad ignition coil is necessary. These should be fixed as soon as a problem is detected. ...

Related Content